文献类型：期刊文献

中文题名：E1级三聚氰胺改性脲醛树脂的制备与性能研究

英文题名：STUDY ON PREPARATION AND PROPERTIES OF E1-TYPE UF RESIN MODIFIED WITH MELAMINE

作者：金立维[1] 王春鹏[1] 赵临五[1] 刘奕[1] 蒋煜[1]

第一作者：金立维

机构：[1]中国林业科学研究院林产化学工业研究所

年份：2005

卷号：25

期号：1

起止页码：40-44

中文期刊名：林产化学与工业

外文期刊名：Chemistry & Industry of Forest Products

收录：CSTPCD;;EI(收录号：2005199092999);Scopus(收录号：2-s2.0-17944379435);CSCD:【CSCD_E2011_2012】；

基金：科技部农业科技成果转化资金资助项目 (03EFN216700299)

语种：中文

中文关键词：脲醛树脂;三聚氰胺;甲醛释放量;固化荆;胶合板

外文关键词：urea-formaldehyde resin; melamine; formaldehyde emission; hardener; plywood

分类号：TQ433.431

摘要：采用三聚氰胺对脲醛树脂进行改性,探讨了改性脲醛树脂的合成工艺对性能的影响。结果表明:当甲醛与尿素的最终摩尔比达到 1. 1∶1,并且酸性阶段的甲醛与尿素摩尔比低于 1. 6∶1时,胶合板甲醛释放量才符合E1级(≤1. 5mg/L)。当三聚氰胺的用量超过 3%,胶合板的胶合强度低于Ⅱ类板 0. 7MPa的标准。在树脂固化时,加入 1 %的异氰酸酯类固化剂可以在提高胶合性能的同时降低甲醛释放量。以三聚氰胺改性脲醛(MUF)树脂压制的胶合板、装饰贴面板、细木工板经检测均符合E1级的标准要求。
Effects of preparation technology of urea-formaldehyde resin modified with melamine(MUF)on property of plywood were studied.Results showed that formaldehyde emission of plywood conformed to E1 degree(≤1.5 mg/L) when formaldehyde/urea molar ratio was 1.1∶1 and F/U molar ratio in weak acid stage was lower than 1.6∶1.The bond strength of plywood using MUF resin in which content of melamine was beyond 3% did not satisfy to the requirement of type Ⅱ plywood (0.7 MPa).It was possible to decrease formaldehyde emission and improve bonding strength by adding 1% isocyanate curing agent in curing stage.Plywood,decorative plywood and blockboard manufactured with this MUF resin conformed to E1 degree required by standard.