文献类型：期刊文献

中文题名：近红外光谱法预测粗皮桉木材气干密度的影响因素分析

英文题名：Influence Factor for Prediction of Air-Dry Density of Eucalyptus Pellita by Near Infrared Spectroscopy

作者：赵荣军[1] 霍小梅[1] 上官蔚蔚[1] 王玉荣[1]

第一作者：赵荣军

通信作者：Wang, Y.-R.

机构：[1]中国林业科学研究院木材工业研究所

年份：2011

卷号：31

期号：11

起止页码：2948-2951

中文期刊名：光谱学与光谱分析

外文期刊名：Spectroscopy and Spectral Analysis

收录：CSTPCD;;EI(收录号：20114614524913);Scopus;北大核心:【北大核心2008】；CSCD:【CSCD2011_2012】；PubMed;

基金：中国林业科学研究院基本科研业务费专项项目(CAFYBB2008008);国家自然科学基金重点项目(30730076)资助

语种：中文

中文关键词：近红外光谱;粗皮桉木材;气干密度;影响因素

外文关键词：Words near infrared（NIR） spectroscopy; Wood of Eucalyptus pellita; Air-dry density; Influence factor

分类号：O657.3;S781.3

摘要：采用近红外光谱分析技术,对粗皮桉木材气干密度校正模型的影响因素进行比较研究。使用直接测量法测量了粗皮桉木材的气干密度,并用近红外光谱仪采集试样的近红外漫反射光谱,对不同切面、厚度、含水率和粗糙度的粗皮桉木材试样的原始光谱进行二阶导数预处理并选择一定光谱段建立回归模型。以50～140个试样作为校正集建立木材气干密度的偏最小二乘法校正模型,使用外部验证法进行验证。结果表明,试样切面、厚度、粗糙度和含水率对粗皮按木材气干密度的预测结果均有影响,其中分别是选取试样横切面、厚度为2～5mm、含水率为12%和粗糙度较细致时的木材试样所建立的各个近红外光谱预测模型效果最好。
Near infrared spectroscopy（NIR）technique was applied to compare the influence factors of Eucalyptus pellita＇s air-dry density.Air-dry density of eucalypt wood was tested by direct measurement.After collecting the near infrared reflectance spectra of samples in different section and with different thickness,moisture content and roughness,the NIR spectra were preprocessed with the second-derivative and the regression models were built in certain spectra.The calibration models were established using 50~140 samples with the partial least squares method and validated with external validation method.The results showed that the predicted results were influenced by sample＇s section,thickness,roughness and moisture content.The best near infrared spectroscopy prediction model was built under the condition of transverse section,2~5 mm thickness,12% moisture content and meticulous roughness of wood.