文献类型：期刊文献

中文题名：塑膜增强薄木贴面高密度纤维板的工艺优化

英文题名：Process Optimization of High Density Fiberboard Overlaid with Veneer Reinforced Using Low Density Polyethylene Films

作者：彭晓瑞[1] 张占宽[1]

第一作者：彭晓瑞

机构：[1]中国林科院木材工业研究所国家林业局木材科学与技术重点实验室

年份：2017

卷号：31

期号：4

起止页码：39-42

中文期刊名：木材工业

外文期刊名：China Wood Industry

收录：CSTPCD;;北大核心:【北大核心2014】；

基金：中央级公益性科研院所基本科研业务费专项资金项目"塑膜衬底柔性装饰微薄木制备关键技术研究"(CAFINT2015K02)

语种：中文

中文关键词：低密度聚乙烯膜;装饰薄木;高密度纤维板;贴面工艺;响应面法;表面胶合强度

外文关键词：low density polyethylene film; reinforced decorative veneer; high density fiberboard （HDF）;overlay; response surface methodology （RSM）; surface bond strength

分类号：TS653

摘要：以塑膜增强红栎装饰薄木为贴面材料,以高密度纤维板(HDF)为基材,采用响应面方法优化贴面工艺,高温热压制备塑膜增强薄木贴面HDF。结果表明:塑膜增强薄木贴面HDF的表面胶合强度受热压温度的影响为极显著影响,受热压压力的影响显著,受热压时间和压力、温度和时间的交互作用影响亦显著。在优化工艺条件下,塑膜增强薄木贴面HDF的表面胶合强度达1.60 MPa,满足GB/T 15104-2006《装饰单板贴面人造板》的要求。
The authors prepared red oak veneer reinforced with low density polyethylene films as a face material to be overlaid on high density fiberboard （HDF）. Response Surface Method was used to optimize the finishing process. The results showed that surface bond strength of the overlaid HDF samples was significantly affected by not only hot pressing temperature and pressure, but also interaction effects between hot-pressing time and pressure as well as jointed effects between hot-pressing temperature and time. Under the optimized process conditions, such as 1 MPa hot-pressing pressure and 130 ~C temperature under 3 minutes duration, the surface bond strength of the overlaid HDF samples reached 1.60 MPa, which met the requirement of the National Standard GB/T 15104-2006 ＂Decorative Veneered Wood-based Panels＂.