文献类型：期刊文献

中文题名：造纸填料级沉淀碳酸钙的壳聚糖覆膜改性与应用

英文题名：Preparation of Chitosan-Coated Papermaking Grade PCC Filler and its Application

作者：沈静[1,3] 宋湛谦[2] 钱学仁[1] 宋成剑[1]

第一作者：沈静

通信作者：Shen, J.

机构：[1]东北林业大学生物质材料科学与技术教育部重点实验室,黑龙江哈尔滨150040;[2]中国林业科学研究院林产化学工业研究所,国家林业局林产化学工程重点开放性实验室,江苏南京210042;[3]华南理工大学制浆造纸工程国家重点实验室,广东广州510640

年份：2008

期号：1

起止页码：21-25

中文期刊名：中国造纸

外文期刊名：China Pulp & Paper

收录：CSTPCD;;EI(收录号：20081011136583);Scopus(收录号：2-s2.0-40049098282);北大核心:【北大核心2004】；

基金：华南理工大学制浆造纸工程国家重点实验室开放基金项目(200620);东北林业大学青年科研基金项目(07007)资助

语种：中文

中文关键词：碱沉淀法;造纸填料;沉淀碳酸钙;壳聚糖覆膜改性

外文关键词：alkali precipitation; papermaking grade filler; precipitated calcium carbonate; chitosan-coating modification

分类号：TS727

摘要：采用碱沉淀法将壳聚糖用于造纸填料级沉淀碳酸钙的覆膜改性,对改性填料的性质及应用性能进行研究。结果表明,碱沉淀法可有效地用于沉淀碳酸钙的壳聚糖覆膜改性,经改性后,填料的Zeta电位增加、白度有所下降,相应加填浆料的滤水性能略有改善,溶解性也有所变化;沉淀碳酸钙的壳聚糖覆膜改性可显著提高加填纸的抗张指数,但加填纸的白度下降、不透明度无明显变化、光散射系数随壳聚糖用量的增加先增大后减小,且当壳聚糖用量在5%以内时,填料留着率有所提高。
Chitosan-coated papermaking grade precipitated calcium carbonate （PCC） filler was prepared by alkali precipitation. The coated amount of chitosan was measured, and the Zeta potential, dissolution behavior, brightness, retention and drainage property of PCC and chitosan-coated PCC, as well as the strength and optical properties of the filled handsheets were investigated. The experimental results showed that chitosan-coated PCC is successfully prepared by alkali precipitation, and the chitosan film can be firmly and effectively coated and anchored on the surface of PCC, and also there is almost no chitosan lost during the PCC modification process. After the chitosan-coating modification, Zeta potential of the filler increases, and the drainage property is slightly improved, and the dissolution behavior and brightness are also changed. The coated PCC was found to be quite effective in the strength property improvement of the filled handsheets as compared with the uncoated PCC, and its retention property is also superior to uncoated PCC when the coated amount is relatively low. Also, it was found that the chitosan-coating modification has no obvious effect on the opacities of the filled handsheets, however the light scattering coefficients of the filled handsheets are somewhat influenced. Based on the experimental results, it is concluded that the cost-effective method of filler modification is efficient in filler property enhancement, and it can possibly make the unmodified water-insoluble chitosan suitable for use in the production of PCC filled paper or paperboard products.